40W Power Isolated LED Driver with 0.4A Current For Batten Light

HT40V-I is Isolated 40W LED Driver & Microwave Motion Sensor Combined 2-in-1 products with 30-54V Output Voltage, Daylight Priority and Detection Range & Height of 6m(H) x 14m(D), Dimming Function with Constant Output LED Current Suitable for Batten Light & Tri-proof Light

Features:

1. Isolated Solution LED Driver & Microwave Sensor Combined

2. Daylight Priority

3. Tri-level control by 1-10V output

4. 3 years warranty, IP20

5. Slim design specially for batten light and tri-proof light

6. Constant Current with options of 0.7A (30-54V)/0.8A (30-48V)/0.90A (30-42V)/0.95A/1.0A (30-36V)

7. Dimming Function with 10%/30% Stand-by Brightness

8. Efficiency of 83%

9. Detection Range x Height of 14M x 6M

10. Output Power 19W max. with Voltage of 30-54V

11. Abnormal protection SCP: Auto recovery, OVP, OCP, OTP

12. EMC standardEN55015

13. Rod Antenna Design to be easily installed.

14. Remote Control setting / DIP Switch Setting

Product Description

Detection Range

This figure indicates the maximum distance at the highest mounting height with 100% sensitivity.

Typical installation height 2.5-4m.

Mechanical structure

With twelve DIP switch poles to set Output Current Setting, Mode Selection, Stand-by Dimming Level, Standy-by Period, Detection Area, Hold Time and Daylight Threshold.

With an IR Receiver to support remote control setting.

With two installation hole, easily fixed to the lighting fixture for end user.

Wiring diagram

Two poles to connect with power supply (120-277VAC)

Two poles to connect with LED Light

Dimensions (mm)

DIP Switch Setting

Daylight Priority

With Daylight priority function, HT19V-I is able to differentiate artificial light brightness
from natural light after installed inside the fixture, and automatically turn off light when
ambient brightness exceeds preset lux level.

Precondition of Daylight priority:
1. Standby period is +∞;
2. Standby dimming level is on 10% or 30%;
3. Daylight threshold is on 2Lux, 10Lux or 50Lux.

Application Demo

1. Automatically ON/OFF function:

Light on when detect movement and off after people leave at night. Applications: Corridor, Staircase.
The daylight threshold is set to "2lux,10lux,50lux"

With sufficient daylight, With insufficient daylight, After the last detection and
even when motion detected, when motion detected, light ON. the present hold time
light remains OFF. elapsed, light OFF.

2. No daylight function
The daylight threshold is set to "Disable".
Light on when detect movement, After people leave, Light off after stand-by period.
Applications: Dim places such as Basement Parking, Underpass.

When motion is detected, After people leave the detection After the last detection and
the sensor will switch on the area, light remains 100% the present hold time
light to 100% brighteness. brightness within hold time. elapsed, light OFF.

3. Function Demo - Dimmable control/Corridor function

With sufficient daylight, With insufficient After last detection, After the stand-by
even when motion daylight, when motion light will be dimmed period, light OFF.
detected, light remains detected, light ON. down to the stand-by
OFF. dimming level (10% or

30%) after holdtime.

Installation Method:

User Notes:

1.Microwave can penetrate walls or glass thinner than 20cm and attenuate if thicker than 20cm.
2. Detection area will be affected by speed of motion, mounting height and movement volume.
3. Conduct test on sunny days without the lampshade which will affect the tested lux value.

Application Case: