Sales

◆ High elastic EPDM rubber tube structure.
◆ Good puncture resistant, abrasion resistance, acid and alkali resistance.
◆ 20 years long lifetime during operation.
◆ Easy to install, only two steps (Cover, pull).
◆ Fast installation, only 15-30 seconds needed to seal one connection.
◆ No limitation of spare space, especially design for narrow space.
◆ Easy to uninstall, only need knife to cut tube open.
◆ No skill required by engineers, uniform quality after installation, stable and good sealing and
◆ Weatherproofing performance.
◆ Much time and labor cost saving.
◆ Good operating capability under hash environmental condition, salt-mist situation, heavy windy weather, and anti-UV, anti-ozone.

Product Detail

Cotran KC96 is an open-ended cold shrink ethylene propylene diene monomer (EPDM) rubber sleeve, which is factory pre-expanded and assembled onto a removable core. The core is removed when the tube is position for installation over an in-line connection or termination lug. It provides a water proofing tight for terminations and joints.

Applications

◆ Protection and repair for outer sheath of high voltage cable joint;

◆ Fire protection of cables and connectors;

◆For all base materials that need to be insulated against fire;

Silicone Cold Shrink Tube

Property

Item		Parameter and Result	Test Method
Waterproof	Class	Pass, IPX7	IEC 60529:1989+A1:1999+A2:2013； 1 meter depth in water, duration: 4 hours
Physical and mechanical properties	Shore Hardness	A/37/1	ASTM D2240-15
	Tensile Strength	≥ 9.6MPa	ASTM D412-15a Method A
	Elongation	≥ 650%	ASTM D412-15a Method A
	Tear Strength	≥ 27 KN/m	ASTM D624-00(2012)
Electricity	Dielectric Strength	≥12 KV/mm	ASTM D149-09(2013) Method A
Material	Environmental protection	RoHS	IEC 62321

Note: This is typical value under lab test, and refer to Cotran KC97 SGS test report.

Models

Model

Color

Cable Size(mm)

Package

KC96-Single

Black

(color can be customized)

Design for 1/2” jumper (7/16 DIN) to Equipment

50 pcs/carton

KC96-Dual

Black

(color can be customized)

Dual-Layerstructure,design for 1/2” jumper (7/16 DIN) to Equipment

50 pcs/carton

Installation Instruction

Step 1
Step 1	1. Wrap the foam tape on the 1/2’’ cable to expand the application outline 2. Put jumper cable inside of the tube, before connectjumper to equipment 3. Arrow symbol will be direction of pulling strip, which usually should be downward
Step 2
	1. Hold the tube, pull stripdownward, and rolling,slowly by slowly 2. Whenpull the white strip till the plastic inner tube is horizontal alignment of the silicone rubber tube, hold cold shrink tube up and attached to bottom of connector on equipment, ensure the tube cover whole metal part of the connector. 3. Hold tube tightly to prevent tube moving, keep pulling strip downward, round and round, till all strip are out.
Step 3
Step 3	1. Hold the foam tape part tightly, clench several times toaccelerate foam tape attached on cables, help EPDM tube shrinking.