Thermal Printer PCB Board Assembly

The thermal printer PCBA is mainly composed of two parts, one part is the thermal printer head (FPC connector, thermistor, motor and motor drive). Another control board, this control board mainly controls the functions of the printer (overheat detection, paper out detection and STB), data interaction and system control. The MCU on the motherboard uses the N32G020K6 chip, the ARM cortex-M0 processor core, and supports DMA. It can directly read the USB and UART interface data, reducing the access to the interface data through the CPU (usually, the data will pass through the control board first) The MCU is then sent to the print head through the SPI interface), the font store Flash can reach 32K bytes, the BIOS burner chip and buttons, etc.

Advantages of this plan:

1) Fast calculation speed, the highest main frequency can reach 80MHz;

2) Fast reading and writing speed and many times, with 2KB instruction cache, 32K bytes flash memory, about 200,000 erasing and writing times;

3) Rich interfaces, supporting up to 30 GPIOs;

4) Support multi-mode low power consumption, working voltage 1.8V-5.5V, the minimum can be kept below 0.1uA;

5) Security, built-in hardware storage protection and encryption and decryption algorithm acceleration engine;

6) Support wireless printing, with Bluetooth chip;

Fast printing speed, 4-wire SPI, with an independent DMA, improve data processing speed;

Compared with conventional solutions, our thermal printer PCBA can work at full speed even in standby mode, with low power consumption, small size, low maintenance cost, fast printing speed and stable performance, and is suitable for mid-to-high-end markets.

FAQ:
Q: Do you have your own factory?
A: Sure, We have our own PCBA factory. Welcome to visite our factory.

Q: Can you provide design the thermal printer PCBA services?
A: Yes,we can help you to design the thermal printer PCBA depend on your requirements.

Q: How long can I get the thermal printer PCBA quotation?

A:  In general, after you confirm engineer's inquiries, 3 working days will send it to you.