DC Input Compact Size Easy For Install Dimmable Function Motion Sensor

Sales DC Input Compact Size Easy For Install Dimmable Function Motion Sensor

DC Input Compact Size Easy For Install Dimmable Function Sensor

Product Detail  

DC Input Compact Size Easy For Install Dimmable Function Sensor


Features of Sensor:

1. Output: 5V PWM (Gradient)

2. With frequency of 5.835GHz-5.875GHz, there is no interference with the 5G Internet

3. Max. detection diameter of 10m with max. moungting height of 4.5m

5. All data are tested under the motion speed of 0.5~1m/s

5. Super compact size of 46*24.4*14.5mm, suitable for all kinds of LED light

6. 10 levels of brightness adjustment (10% for each pressing)


Product Description of  Sensor:

Control method On/off / 5V PWM (Gradient)
Microwave frequency 5.835GHz-5.875GHz
Operating voltage 7-12VDC
Stand-by power ≤0.5W
Package Bubble pac,Cardboard compartments
Operating current <30mA±5%
Microwave power <0.3mW
IP grade IP 20
Operating temperature -20°C~+60°C
Warranty 5 years


Mechanical structure of Motion Sensor:

Detection area Very near/Near/Medium/Far
Hold time OFF/30s/10min/30min
Daylight threshold OFF/ Over cast/Dusk/Night
Stand-by period OFF/30s/10min/30min
Stand-by dimming level Remarks: Stand-by dimming level is defaulted to be half brightness of hold time.Light dim down gradually until off.






Dimensional drawing (Unit: mm) of Motion Sensor:

Compact size suitable for all kinds of lamps.


Wiring diagram of Motion Sensor:

Control method On/off / 5V PWM (Gradient)
Microwave frequency 5.835GHz-5.875GHz
Operating voltage 7-12VDC
Wire color Red:VCC,Black:GND,White:PWM


Detection coverage of Motion Sensor:


Typical installation height 2-3m
This figure indicates the maximum distance at the highest mounting height with 100% sensitivity.
Mounting height Max. 4.5m/14.76 (ceiling mounted)
Detection range Max.ø10m/32.8ft (ceiling mounted)
Detection angle 30°~150°
Motion detection 0.5~1.5m/s


Installation of DC motion sensor:

3 pin connector,plug and plug,very easy to install and easy to use by end customer.

Installation precautions of motion sensor 1. Microwave sensor can be installed in any lamp except the one with full metal shell.
2. The detected surface cannot be shielded by metal objects.
3. Make sure the microwave module is completely exposed outside.
4. The detection surface of the sensor module shall be installed facing the detection area.
5. Should be kept away from the driver to avoid interference generation and lamp flashing.
6. Wiring must be strictly in accordance with the wiring diagram to avoid short circuit.



Leave A Message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.
X

Home

Supplier

Leave a message

Leave a message

If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.