New coronavirus test is used for the qualitative detection of novel coronavirus (COVD-19) antigen in human throat swab and nasal swab samples,only for in vitro diagnostic use.

The novel coronaviruses belong to theβ genus. COVID-19 is an acute respi-ratory infectious disease.People are generally susceptible.

Currently, the patients infected by the novel coronavirus are the main source of infection; asymptomatic infected people can also be an infectious source.

Based on the current epidemiological investigation, the incubation period is 1 to 14 days, mostly 3 to 7 days.The main manifestations include fever, fatigue and dry cough. Nasal congestion,runny nose,sore throat, myalgia and diarrhea are found in a few cases.

Antigen is generally detectable in upper respiratory specimens during the acute phase of infection.Rapid diagnosis of SARS-CoV-2 infection wil help healthcare professionals to treat patients and control the disease more efficienty and efectively.

Feature

• 2-Steps easy to operate  
• Quick result within 15 mins
• All necessary consumables included
• No instrument needed suitable fot mass screening
• Based on immunoassay more practical than PCR test

Test procedure

Insert the swab (after collection) into the sampling tube containing individual lysis buffer. Rotate the swab against the inner tube wall 10times and squeeze the swab from the outer tube wall 5 times to completely dissolve the sample in the buffer, then move the swab up until it is resting on the sample solution, squeeze the swab from the outer tube wall in order to leave the sample in the tube as much as possible. Remove and discard the swab,cover the tube with the dropper. Open the aluminum foil pouch,take out the test cassette and lay it on a clean flat surface， add 4 drops （approximately 100 μL） processed sample extract into the sample well. The result should be observed within 15-20 minutes. Result observed after 20 minutes is invalid.

1.Kit Contents for Oral Secretion test

2.Insert the swab into the nasal cavity,gently spin and push the swab forward until blocked by turbinate. Then rotate and rub the swab on the cavity wall 3 times.

3.Tear the seal of sampling tubes containing individual lysis buffer.

4.Insert the swab into the sampling tube and rotate the swab against the inner tube wall 10 times

5.Squeeze the swab from the outer tube wall 5 times

6.Squeeze the swab from the outer tube wall

7.Cover the tube with the dropper

8.Add 4 drops processed sample extract into the sample well

9.Observe the results within 15-20 minutes