Sales

The die casting machine has the advantages of few operation, high efficiency and easy automation.Our die casting machines can make door handles, electric cases, LED light housings and many other products.

Product Detail

Product Item:

1000T After-sales Service Cold Chamber Die Casting Machine

After-sales Service Cold Chamber Die Casting Machine

Our Promise

Customer satisfaction is our eternal pursuit, longhua always pay attention to customer needs, in order to reduce customer mechanical failure time, longhua service center after ten years precipitation a set of perfect server process, with the fastest response cycle for customers to repair machines, improve customer machine operating rate.

1000T After-sales Service Cold Chamber Die Casting Machine parameter

Items	Unit	Specification
Hydraulic Working Pressure	MPa	16
Clamping Force	KN	10000
Space Between Tie Bars	mm	930*930
Tie Bar Diameter	mm	￠180
Die Opening Stroke	mm	800
Injecction Force(intensify)	KN	775
Plunger launch distance	mm	300
Injection position	mm	0 -- 250
Plunger Diameter	mm	￠80----￠110
Injection Stroke	mm	760
Casting pressure (intensify)	MPa	154/121/98/81
Casting Fiange Protrusion	mm	20
Casting Fiange Diameter	mm	200
(40Mpa) Max Casting Area Under 40Mpa	CM²	2250
lnjection Weight(Al)	Kg	15
Die Height(Min--Max)	mm	400～1000
Ejector Force	KN	360
Ejector Steoke	mm	190
Motor Capacity	Kw	37
Machine Dimensions (LWH)	m	102.73.3
Referential Machine Weight For Uplifting	T	45
Oil Tank Capacity	L	1600

WE reserve the right to make any technical improvement without further notice

Safe operation rules for aluminum alloy die casting machine

1.Aluminum alloy die casting machine before starting up, the first need to put the pressure relief valve handle in the pressure relief position, until the normal operation of the motor, and then release the pressure relief valve handle.

2. Aluminum alloy die casting machine must heat the model to the specified temperature before shooting, and then can be pressed into the metal solution.

3. Protective baffle should be used at the contact point of mold parting surface and gate. Operators must wear protective glasses.The operator shall not stand on the opposite side of the parting surface contact.Prevent metal liquid spatter injury.

4. Do not bring naked fire near the fuel tank.Water cooling shall be applied when the tank temperature exceeds the specified operating temperature of the equipment.

5. Tools should be used when removing castings and casting risers from die casting molds.After removing the casting, the metal residue adhering to the mold and the air hole should be removed in time.

6. When the work is finished, the oil pump must be stopped and all valves closed.If the insulation furnace is used for the insulation of metal liquid, turn off the power supply and stop the ventilation equipment on the insulation furnace.